New Application Note: Monitoring ALD Thin Film Coverage & Growth by XPS Structure Modeling with StrataPHI
Understanding what happens during the earliest stages of atomic layer deposition (ALD) is essential for optimizing ultra-thin film performance. While ALD is often described as a layer-by-layer process, real-world film growth can be far more complex during the first deposition cycles.
In our latest application note, StrataPHI structure modeling software is used to analyze Al₂O₃ deposited on SiO₂/Si substrates, providing both film thickness and surface coverage information from a single XPS measurement. The results reveal that early-stage growth follows a Volmer-Weber-like island growth mechanism, where isolated Al₂O₃ islands nucleate and spread laterally before forming a continuous film.
Key Highlights
- Simultaneous determination of Al₂O₃ thickness and fractional coverage using StrataPHI and XPS.
- Coverage increases from approximately 27% to 82% during the initial ALD cycles while effective thickness remains near 0.5 nm, indicating lateral island growth.
- Independent LEIS measurements validate StrataPHI fractional coverage calculations, demonstrating strong agreement between the techniques.
- StrataPHI provides a non-destructive XPS-based alternative to ISS/LEIS that delivers coverage, thickness, and chemical-state information from a single XPS acquisition.
Whether you're studying ALD nucleation behavior, thin-film uniformity, or surface coverage evolution, this application note demonstrates how XPS combined with StrataPHI can provide deeper insight into film-growth mechanisms.
Read the full application note to see how coverage and thickness analysis can reveal details often overlooked by conventional thin-film measurements.

StrataPHI-calculated Al2O3 thickness and fractional coverage on SiO2/Si substrate as a function of atomic layer deposition (ALD) cycle number.